Epson TM-T88III Programming Manual page 293

C O N F I D E N T I A L
[Default] None
[Printers not featuring this command] TM-L60II, TM-P60, TM-U230, TM-U220, TM-U210,
[Description] Prints a raster bit image using the mode specified by
m
0, 48
1, 49
2, 50
3, 51
•
•
•
•
[Recommended Functions]
This command is supported by only some of the printer models and will not be supported by future models.
It is recommended to use graphics function (GS ( L
graphics function is superior in operating to
• Selecting a color for printing is possible.
• Size setting in dot unit is possible.
[Notes]
When standard mode is selected, this command is enabled only when there is no data in the print buffer
and printer is in the beginning of the line. If data exists in the print buffer, the printer processes
following data as normal data.
In page mode, the bit image is only stored in the print buffer and is not printed.
Paper roll Bit-image commands
0 ≤ ≤ 8
y
H
0 ≤ ≤ 255
d
k x
= ( +
L
Mode
Normal
Double-width
Double-height
Quadruple
× 256) bytes in horizontal direction for the bit image.
x , x specifies ( x + x
L H L H
× 256) dots in vertical direction for the bit image.
y y y y
, specifies ( +
L H L H
d
specifies the bit image data (raster format).
k
indicates the number of bit image data.
be transmitted.
GS v 0
× 256) × ( × 256) (except for
x y y
+
H L H
m
, as follows:
Scaling for horizontal Scaling for vertical
× 1
× 2
× 1
× 2
k
is an explanation parameter; therefore, it does not need to
GS 8 L: <Function 50> and <Function 112> ). The
GS v 0 for the following reasons:
k
= 0)
TM-U300A/B
× 1
× 1
× 2
× 2
Ver. 10.01 p. 293
m
and the