Epson TM-T88III Programming Manual page 409

C O N F I D E N T I A L
• The selection of peripherals after ESC @ is executed is shown in the next table.
Setting when
power supply is
turned on
Setting immediately before execution of ESC @
Setting after
ESC @ is executed
• In the model not equipped with the switch of the parallel interface specification and the connection of
[Model-dependent variations]
Program Example for all printers
PRINT #1, CHR$(&H1B);"=";CHR$(1); ← Printer enabled
PRINT #1, "AAAAA";
PRINT #1, CHR$(&H1B);"=";CHR$(2); ← Printer disabled
PRINT #1, "BBBBB";
PRINT #1, CHR$(&H1B);"=";CHR$(3);← Pinter enabled
PRINT #1, " CCCCC"; CHR$(&HA);
TM-J2000/J2100
The memory switch which selects the connection of DM-D (customer display) is Msw 1-6.
TM-L60II
DLE EOT is not available when the printer is not selected.
TM-U210, TM-U220, TM-U230, TM-T88III, TM-T90, TM-L90,
There is no memory switch to select the connection of a DM-D (customer display).
Paper roll Miscellaneous commands
When the switch of the [DM-D (customer display) connection] is turned off
When the switch of the [DM-D (customer display) connection] is turned on
When the switch of the [DM-D (customer display) connection] is turned off
When the switch of the [DM-D (customer display) connection] is turned on
DM-D (customer display), the settings are the same as when the switch in the above table is off.
TM-J2000/J2100, TM-L60II, TM-U210, TM-U220, TM-U230, TM-T90, TM-L90,
TM-P60
AAAAA CCCCC
TM-P60
ESC =
Print Sample
Ver. 10.01 p. 409
n
1
2
1 2 3
1 2 1
1 2 2