Epson TM-T88III Programming Manual page 583

C O N F I D E N T I A L
• Settings of [Msw 8-6] affect the initializing operation when the power is turned on, when the paper layout
(origin of layout) is "bottom of a label" or "top of a black mark". Paper layout can be set by this function
(Function 49) or "automatic setting of paper layout" function (by GS ( A (m = 64) or panel operation).
• When [Msw 8-6] is set to
turned on), printer performs assuming that paper is set to the print starting position. Therefore, user
should note the following.
a) Turn off the power after feeding paper to the print starting position.
b) Do not open the roll paper cover or replace roll paper when power is off.
c) If the roll paper cover is opened while power is off, open the cover to feed paper to the print start
position after the power is turned on.
d) If the print starting position is not set when power is turned on, the print position of the first sheet
may shift, or a paper layout error may occur.
Setting the memory switch ([Msw 1-2] ~ [Msw 1-4], [Msw 1-7], [Msw 1-8], [Msw 2-2], [Msw 8-4]) can be
changed by "Memory switch setting mode" by the panel switch operation when the power supply is turned
on.
TM-P60
a
• When = 8, memory switch 8 is set as follows:
Msw Setting value (
8-1 48
49
8-2 48
49
8-3 48
49
8-4 48
49
Paper roll Customize commands
b
= 49 (does not perform paper feed to the print starting position, when power is
b
) Function
Power ON/Power OFF notification transmission and battery status is not
transmitted automatically
Power ON/Power OFF notification transmission and battery status is
transmitted automatically
No beeps for low battery
Beeps for low battery
No beeps for host disconnection
Beeps for host disconnection
No beeps for roll paper end
Beeps for roll paper end
GS ( E Ver. 10.01 p. 583