Epson TM-T88III Programming Manual page 384

C O N F I D E N T I A L
With a serial interface, the printer executes this command even when it is in offline, receive buffer full.
With a parallel interface, if the printer is in BUSY condition, this command cannot be used in the following
states.
• When DIP switch (BUSY condition) is on: receive buffer full
• When DIP switch (BUSY condition) is off: offline, receive buffer full, or error status
This command is effective when the printer is disabled by ESC = (select peripheral device).
[Model-dependent variations]
PRINT #1, CHR$(&H10);CHR$(&H14);CHR$(1)l;CHR$(0);CHR$(5);
TM-J2000/J2100
The BUSY condition is selected by memory switch 1-3.
TM-T90
The BUSY condition is selected by memory switch 1-3.
TM-L90
The BUSY condition is selected by memory switch 1-3.
TM-T88III
The BUSY condition is selected by memory switch 2-1.
TM-U220
The BUSY condition is selected by memory switch 1-8.
Paper roll Miscellaneous commands
TM-J2000/J2100, TM-T90, TM-L90, TM-T88III,
Program Example
DLE DC4 (fn = 1)
TM-U220
Ver. 10.01 p. 384