Adjust Label Print Starting Position - Epson TM-T88III Programming Manual

C O N F I D E N T I A L
GS A
[Name]

Adjust label print starting position

[Format] ASCII
Hex
Decimal
0 ≤
[Range] m
m
[Default] = 0,
[Printers not featuring this command] TM-J2000/J2100, TM-T90, TM-T88III, TM-L90, TM-P60, TM-U230, TM-U220,
[Description] Adjusts the label print starting position in a selected direction and by a specified amount from the default
position.
•
•
[Recommended Functions]
This command is supported only by some printer models and may not be supported by future models.
GS ( E
same function as this command.
[Notes]
This command is effective only when label is selected, and it is received just after feeding a label to the
print starting position in the condition shown below:
• When resetting the printer or turning on the power.
• Just after executing FF, GS FF, GS <, or GS A.
• Just after performing paper feed by pressing the paper feed button
When calculating the adjustment amount, the vertical motion unit (
When executing this command, the paper is fed to adjust the print starting position of the current label.
Paper roll Miscellaneous commands
Miscellaneous commands
m n
GS A
m n
1D 41
m n
29 65
≤ 255, 0 ≤ ≤ 255
n
n
= 0
TM-U210, TM-U300A/B
m specifies the adjustment direction as follows:
m
When the LSB of is 0, the label position is adjusted in the normal direction.
When the LSB of m is 1, the label position is adjusted in the reverse direction.
n
specifies the adjustment amount as (
is recommended for adjusting the label print starting position. GS ( E <Function 49> can perform the
× vertical motion unit).
n
GS A
obsolete command
obsolete command
E
XECUTING
y ) is used.
Ver. 10.01 p. 452
+ S
ETTING