Epson TM-T88III Programming Manual page 652

C O N F I D E N T I A L
TM-L90
When it meets either of the following requirements, bit 0 of [Position Information B] becomes
"The print start operation of the label is possible now." Set the paper layout (
Function 49 of GS ( E.
(1) When position information A is "Standby at the label peeling position" (soon after executing
this command
If (
If (
(2) When position information A is "Standby at the cutting position" (soon after executing this
command fn = 66) and when it meets either of the following requirements:
If (
If (
When it meets either of the following requirements, bit 1 of [Position information B] becomes
"The print start operation of the next label is possible."
(1) When position information A is "Standby at the label peeling position" (soon after executing
this command
If (
If (
(2) When position information A is "Standby at the cutting position" (soon after executing this
fn
command = 66) and when it meets either of the following requirements:
If (
If (
Paper roll Printing paper commands
fn = 65) and when it meets either of the following requirements:
≤ ), 24 mm {0.94 inch} ≤ (
se sd
), 24 mm {0.94 inch} ≤ (
sd se
<
≤ ), 14 mm {0.55 inch} ≤ (
se sd
), 14 mm {0.55 inch} ≤ (
sd se
<
fn
= 65) and when it meets either of the following requirements:
≤ ), 24 mm {0.94 inch} ≤ (
se sd
), 24 mm {0.94 inch} ≤ (
sd < se
≤ ), 14 mm {0.55 inch} ≤ (
se sd
), 14 mm {0.55 inch} ≤ (
sd < se
) and 3.6 mm {0.14 inch} ≤ (
sb - se
× 2 - ) and 3.6 mm {0.14 inch} ≤ (
sb se
) and 3.6 mm {0.14 inch} ≤ (
sb - se
× 2 – ) and 3.6 mm {0.14 inch} ≤ (
sb se
× 2 – ) and 3.6 mm {0.14 inch} ≤ (
sb se
× 3 – ) and 3.6 mm {0.14 inch} ≤ (
sb se
× 2 – ) and 3.6 mm {0.14 inch} ≤ (
sb se
× 3 – ) and 3.6 mm {0.14 inch} ≤ (
sb se
FS ( L
sb , sd , se ) using
sd - se )
sb sd se
+ – )
sd - se )
sb sd se
+ – )
sb sd se
+ – )
× 2 +
sb sd – se )
sb sd se
+ – )
× 2 +
sb sd – se )
Ver. 10.01 p. 652