Epson TM-T88III Programming Manual page 250

C O N F I D E N T I A L
A horizontal maximum print area is decided according to the width of the paper.
When paper
layout is not used
or top of black
mark is selected
When the bottom
of label is
selected
TM-P60
The dot density and the maximum print area are described in the next tables (dpi: number of dots per 25.4
mm).
"Vertical" is in the direction of paper feeding and "horizontal" is perpendicular (at right angles) to the
direction of paper feeding.
The maximum print area in the vertical direction is information used when graphics are printed with the page
mode selected (for the starting position specified with ESC T is "Upper right" or "Lower left"). In this case,
graphics rotated by 90 degrees or 270 degrees are printed.
See Function 5 of GS ( E for the paper width.
Dot
Scaling density
× 1
203 dpi
× 2
203/2 dpi
Paper roll Bit-image commands
Paper width When (x = 1) is specified.
80 to 78 mm 576 dot
(256 + (paper width – 38) × 8) dot (256 + (paper width – 38)
77 to 38 mm
80 mm 560 dot
(224 + (paper width – 38) × 8) dot (224 + (paper width – 38) × 8 / 2) dot
79 to 38 mm
Horizontal
Maximum print area (dot)
Paper width Paper width
58 mm 60 mm
420 432
210 216
GS ( L GS 8 L
When (x = 2) is specified.
288 dot
280 dot
Vertical
Dot Maximum print area
density (dot)
203 dpi 1200
203/2 dpi 600
×
8 / 2) dot
Ver. 10.01 p. 250