Epson TM-T88III Programming Manual page 446

C O N F I D E N T I A L
TM-L90
The following print densities are available.
m Print density
Criterion density × 70%
250
Criterion density × 75%
251
Criterion density × 80%
252
Criterion density × 85%
253
Criterion density × 90%
254
Criterion density × 95%
255
0 Criterion density
Criterion density × 105%
1
Criterion density × 110%
2
Criterion density × 115%
3
Criterion density × 120%
4
Criterion density × 125%
5
Criterion density × 130%
6
Criterion density × 135%
7
Criterion density × 140%
8
A criterion density is the print density set by Function 5 (a = 5) of GS ( E.
The print density actually set is as follows.
For Example: If (m = 4) is specified when 90% in a standard density is set, the print density becomes 110%
[90%×20%].
The print density can be only within the range of 70% to130%. When it is set to exceed 130%, the print
density becomes 70% or 130%.
For example: If (m = 6) is specified at 120% in a standard density, the print density becomes 130%
though the calculated value is 150% [120%×130%].
Paper roll Miscellaneous commands GS ( K Ver. 10.01 p. 446