Epson TM-T88III Programming Manual page 311

C O N F I D E N T I A L
Bit 2 of the error cause status is not supported.
Roll paper sensor status (
Bits 2 and 3 of the roll paper sensor status are not supported.
When the roll paper cover is open, paper detection (detected by the roll paper end sensor) may be
incorrect.
TM-U230
BUSY condition for a parallel interface is selected by DIP switch 1-8.
Printer status (
Bit 6 of the printer status is undefined.
TM-U210
BUSY condition for a parallel interface is selected by DIP switch 1-8.
Printer status (
Bit 6 of the printer status is undefined.
Offline status (
Bit 2 of the offline status is undefined.
Roll paper sensor status (
The roll paper near-end sensor is an option. If the printer is not equipped with the paper near-end
sensor, bits 2 and 3 of the third byte are always ON, "Paper adequate."
Paper roll Status commands
n
= 4)
n
= 1)
n
= 1)
n
= 2)
n
= 4)
DLE EOT Ver. 10.01 p. 311