Epson TM-T88III Programming Manual page 351

C O N F I D E N T I A L
In CODE A, following data can be used.
In CODE B, following data can be used.
In CODE C, following data can be used.
Special characters are defined by combining two characters "{ + an alphanumeric character." The ASCII
character "{" is defined by transmitting "{" twice consecutively.
Specific character
SHIFT
CODE A
CODE B
CODE C
FNC1
FNC2
Paper roll Bar code commands
Character data: It is specified by ASCII code [in hexadecimal: 20H ~ 5FH / in decimal: 32~95]
Control character data: It is specified by ASCII code [in hexadecimal: 00H ~ 1FH / in decimal: 0~31]
Special character data: (FNC 1, FNC 2, FNC 3, FNC 4, SHIFT, CODE B, CODE C)
It is specified "{+ character code" as 2 byte. (It is described separately.)
Character data: It is specified by ASCII code [in hexadecimal: 20H ~ 7FH / in decimal: 32~127]
when specify "{", transmit "{{" as 2 byte data. (It is described separately.)
Special character data: (FNC 1, FNC 2, FNC 3, FNC 4, SHIFT, CODE A, CODE C)
It is specified "{+ character code" as 2 byte. (It is described separately.)
Numerical data: It is specified each 2 digit as 1 byte by ASCII code
[in hexadecimal: 00H ~ 63H / in decimal: 0~99]
Example: When specify "012345", specify [in hexadecimal: 01H, 17H, 2DH.
in decimal: 1, 23, 45] as 3 byte.
Special character data: (FNC 1, CODE A, CODE B)
It is specified "{+ character code" as 2 byte. (It is described separately.)
Transmit data
ASCII Hex
{S 7B, 53 123, 83
{A 7B, 41 123, 65
{B 7B, 42 123, 66
{C 7B, 43 123, 67
{1 7B, 31 123, 49
{2 7B, 32 123, 50
GS k
Decimal
Ver. 10.01 p. 351