Epson TM-T88III Programming Manual page 287

C O N F I D E N T I A L
TM-T88III
This command can be used in standard mode only.
The dot density and the maximum print area are described in the next tables (dpi: number of dots
per 25.4 mm).
"Vertical" is in the direction of paper feeding and "horizontal" is perpendicular to the direction of
paper feeding.
The maximum print area in the vertical direction is information used when graphics are printed
with the page mode selected (for the starting position specified with ESC T is "Upper right" or
"Lower left"). In this case, bit images rotated by 90 degrees or 270 degrees are printed
Scaling Dot density Maximum print area (dot) Dot density
×
1
180 dpi
×
2
90dpi
TM-L60II
The dot density and the maximum print area are described in the next tables (dpi: number of dots
per 25.4 mm).
"Vertical" is in the direction of paper feeding and "horizontal" is perpendicular (at right angles)
to the direction of paper feeding.
The maximum print area in the vertical direction is information used when graphics are printed
with the page mode selected (for the starting position specified with ESC T is "Upper right" or
"Lower left"). In this case, bit images rotated by 90 degrees or 270 degrees are printed.
Scaling Dot density
×
1
180 dpi
×
2
90dpi
Paper roll Bit-image commands
Vertical
831
415
Vertical
Maximum print area (dot)
Thermal label paper Thermal roll paper
368 384
184 192
GS /
Paper width 80 mm
180 dpi 512
90 dpi 256
Dot density Maximum print area (dot)
180 dpi
90 dpi
Horizontal
Maximum print area (dot)
Paper width 58 mm
360
180
Horizontal
831
415
Ver. 10.01 p. 287