Epson TM-T88III Programming Manual page 162

C O N F I D E N T I A L
[Notes]
This command is enabled only with a parallel interface and is ignored with a serial interface.
The roll paper near-end sensor is enabled when either bit 0 or bit 1 is on or both are on.
The roll paper end sensor is enabled when either bit 2 or bit 3 is on or both are on.
It is possible to select multiple sensors to output signals. When any of the sensors detects a paper-end, the
paper-end signal is output.
When all sensors are disabled, the paper-end signal is always paper present.
Some sensors are not present, depending on the printer model.
The names of some sensors differ, depending on the printer model.
The settings of this command are effective until ESC @ is executed, the printer is reset, or the power is
turned off.
[Model-dependent variations]
PRINT #1, CHR$(&H1B);"c3";CHR$(4); ← Roll paper end sensor enabled
TM-T90
The memory switch can be set by Function 3 of GS ( E.
TM-T88III
DIP switch SW1-3 is supported differently, depending on the version of the firmware.
TM-U220, TM-U210
The roll paper near-end sensor is an option. If the roll paper near-end sensor is not included, this
printer does not detect a roll paper near-end.
TM-U300A/B
Bits 1 and 3 are undefined.
Paper roll Paper sensor commands
TM-T90, TM-T88III, TM-U220, TM-U210,
Program Example for all printers
ESC c 3
TM-U300A/B
Ver. 10.01 p. 162