Epson TM-T88III Programming Manual page 459

C O N F I D E N T I A L
Printer ID is distinguished from other send data by bits 4 and 7. When the data sent from printer after
printing GS I is "0xx0xxxx" (x = 0, 1), the printer processes the data as printer ID.
[Notes for printer information A]
Printer information A (n = 33, 96) consists of [Header ~ NUL] as shown in the following table:
Transmitted data
Header
Identifier(*1)
Printer information A (*2)
NUL
(*1) The identifier is transmitted as the transmitted parameter n of this command.
Example: When type information is specified (n = 33), the identifier is [hex = 21H/decimal = 33].
(*2) If the printer information cannot be transmitted, the printer transmits 3-byte code of [Header +
Identifier + NUL].
The printer information A of type information (n = 33) is 2 bytes of data as shown in the following tables.
Bit
0
1
2
3 ~ 5 -
6
7
Paper roll Miscellaneous commands
Hex
3DH
20H ~ 2FH
Depends on printer model Depends on printer model 0 ~ 80 bytes
00H
Off/On Hex Decimal Function
Off 00 0 Multi-byte code character (Kanji) is not
supported.
On 01 1 Multi-byte code character (Kanji) is supported.
Off 00 0 Autocutter is not installed.
On 02 2 Autocutter is installed.
Off 00 0 DM-D (Customer display) is not connected.
Off 04 4 DM-D (Customer display) is connected.
- - Reserved.
On 40 64 Fixed.
Off 00 0 Fixed.
Decimal
61
32 ~ 47
GS I
Amount of data
1 byte
1 byte
1 byte
... how to use
this table
Ver. 10.01 p. 459