Gs T - Epson TM-T88III Programming Manual

C O N F I D E N T I A L

GS T

[Name] Set print position to the beginning of print line
[Format] ASCII
Hex
Decimal
[Range] n = 0, 1, 48, 49
[Default] None
[Printers not featuring this command] TM-T88III, TM-L60II, TM-P60, TM-U230, TM-U220, TM-U210,
[Description] In standard mode, moves the print position to the beginning of the print line after performing the operation
specified by
n
0, 48
1, 49
[Notes]
In page mode, this command is ignored.
This command is ignored if the print position is already the beginning of the line.
If the print position is not set to the beginning of the line, when
same as LF.
Setting values of each command, definitions, and receive buffer content are not changed.
By processing this command, the print position moves to the left of the print area. The printer will be in
the beginning of the line and data will not be in the print buffer.
When using commands that are enabled only at the beginning of the line, these commands are sure to be
executed if GS T is used immediately before using those commands.
Paper roll Print position commands
Print position commands
n
GS T
n
1D 54
n
29 84
n
.
Function
Cancel data in the current print buffer
Print data in the current print buffer
GS T
E
XECUTING COMMAND
TM-U300A/B
n
= 1, 49, this command functions the
Ver. 10.01 p. 187