Epson TM-T88III Programming Manual page 274

C O N F I D E N T I A L
The relationship between graphics data (column format) and print results is shown in the table below.
d1 d
d2 d
: :
d d
Y
This printer is equipped with a print head configured in column format, which makes it faster to define
data using this function (column format) than with Function 112 (raster format).
[Model-dependent variations]
TM-J2000/J2100
This printer is equipped with a print head configured in column format, which makes it faster to
define data using Function 113 (column format) than with this function.
Use the following settings for best performance.
Specify the horizontal size of graphics as 64 dots and horizontal
× 256) = 64,
y y
[( +
L H
Specify the horizontal size of graphics as 128 dots and horizontal
× 256) = 128,
[( y + y
L H
The dot density and maximum print area are the same as Function 69. See the model information
of Function 69.
TM-T90
This printer does not support this function.
TM-L90
This printer does not support this function.
TM-P60
This printer does not support this function.
Paper roll Bit-image commands
+1 ... :
Y
dk
+2 ... -2
Y
... dk -1
dk Y y y
x2 ... = ( +
Y L
TM-J2000/J2100, TM-T90, TM-L90,
= 1] when setting the dot density to [180 dpi × 180 dpi] with Function 49.
bx by
= 1,
= 1] when setting the dot density to [360 dpi × 360 dpi] with Function 49.
bx = 1, by
GS ( L GS 8 L
× 256)
H
TM-P60
× vertical
single single
× vertical
single single
Ver. 10.01 p. 274
size settings
size settings