Dle Dc4 (Fn = 1); Generate Pulse In Real-Time - Epson TM-T88III Programming Manual

C O N F I D E N T I A L

DLE DC4 (fn = 1)

[Name]

Generate pulse in real-time

[Format] ASCII
Hex
Decimal
[Printers not featuring this command] TM-L60II, TM-P60, TM-U210, TM-U230,
n
[Range] = 1
m
= 0, 1
1 ≤ ≤ 8
t
[Description] Outputs the pulse specified by
m Connector pin
0 Drawer kick-out connector pin 2
1 Drawer kick-out connector pin 5
The pulse ON time is [
[Notes]
This is a real-time command that the printer executes upon receiving it. Note the following when using
this command.
• If this command is embedded within the code string of another command, it is processed as a
• If another command (such as graphics data or defined data) has a code string in a parameter that is the
This command is ignored in the following states:
• In error status
• When the pulse is being output to the connector pin (during processing of ESC p and DLE DC4)
• During transmission of block data (Header ~ NUL)
• When this command is disabled by GS (D
Paper roll Miscellaneous commands
Miscellaneous commands
n m t
DLE DC4
n m t
10 14
n m t
16 20
t
× 100 ms] and the OFF time is [
t
parameter of the other command, and the print result is not correct.
same as this command, the printer starts processing this command.
m
to connector pin as follows in real time:
× 100 ms]
t
DLE DC4 (fn = 1)
TM-U300A/B
Ver. 10.01 p. 383
E
XECUTING COMMAND