Epson TM-T88III Programming Manual page 605

C O N F I D E N T I A L
Changes the data of the user-defined code page that is copied into the work area by Function 7.
If data in the user-defined code pages is not copied into the work area, this function is not available. In this
case, execute Function 7 first.
Definition data (
bytes.
When defining the character of the Font No. 10 (configuration: 9 × 17), only the MSB can be used in the
third byte for vertical direction. All bits can be used when defining characters of other fonts.
Definition data (
the number of dots composing the built-in character, any remaining dots on the right side are blank.
Deletes the character data defined in the same code.
Function 9 can also define character data. It is recommended that either of the functions be used, even if
both functions are supported.
• Definition area and printing results are the same in both functions, although Function 8 processes the
The relation between the definition data and printing result is as follows.
Example: Characters composed of 24 × 12 dots (
d1
d2
d3
[Model-dependent variations]
TM-P60
This printer doesn't support this function.
TM-U220
This printer doesn't support this function.
Paper roll Customize commands
d
) specifies a bit printed to 1 and not printed to 0. The data to define a character is (
d
) defines the
data in column format, and Function 9 processes the data in raster format.
d4 d7 ... d28
d5 d8 ... d29
d6 d9 ... d30
TM-P60, TM-U220
GS ( E
x
dots pattern from the left side of the characters. When
y = 3, x = 12)
d31 d34
MSB
LSB
d32 d35
MSB
LSB
d33 d36
MSB
LSB
y × x
)
x
is smaller than
Ver. 10.01 p. 605