Characters; Cutting Position From Print Start Position - Epson C31C514452 Technical Reference Manual

6.1.1.2 Characters

TM-U220 has almost the same character spec as the TM-U210. Therefore, the TM-U220 can print
the same contents as the TM-U210 without adjusting any original control sources.
Character spec
Character Font A (9 x 9)
par line
Font B (7 x 9)
(CPI)
Kanji (16 x 16)
Character Font A (9 x 9)
width
Font B (7 x 9)
Kanji (16 x 16)
Character configuration
Note:
The character per line for Font A, B can be changed by DIP SW2-1.
The cpl for the Kanji character font can be changed by an ESC/POS command. (default:22cpl to 25cpl)

6.1.1.3 Cutting position from print start position

TM-U220 has same distance between the auto cut position and the print start position as the
TM-U210. Therefore the top margin is the same as the previous one when you replace the
TM-U210 with the TM-U220 with autocutter. In other cases, please refer the table and figures
below.
Cutting position
Autocutting position to print start
position
Manual cut position to print start
position
Cutting method of partial cut
6-2 Notices for Replacement of the TM-U210/TM-U300
TM-U210 (Type A,B,D)
33 (35) cpl
40 (42) cpl
25 (22) cpl
1.6 x 3.1
1.2 x 3.1
2.7 x 2.7
Code page 0 to 8, and
19 to 26
TM-U210 (Type A,B,D)
27mm
20.2mm
one point left uncut position at
center position.
(Type A, B only)
TM-U220 (Type A,B, D)
33 (35) cpl
40 (42) cpl
25 (22) cpl
1.6 x 3.1
1.2 x 3.1
2.7 x 2.7
Code page 0 to 8, and 19 to
26 and code page 16, 17, 18
TM-U220 (Type A,B, D)
27mm
Type D: 22.1mm
TypeA,B: 34.9mm
one point left uncut position at
right position.
(Type A, B only)
Rev. H