Table of Contents
Advertisement
Roll Paper Print Position and Cut Positions
Emergency cutter cut position
Auto cutter cut position
Head printing center position
• Values are standard values. Paper slack can cause actual values to be somewhat different. For the
auto cutter cut position setting, take the variation in the value into consideration.
• When removing cut paper, pulling the paper at the uncut edge can cause reduced printing pitch
for the first line of the next receipt. When performing a print operation after cutting paper, it is
recommended that paper be fed approximately 1 mm (14/360 inches) immediately before print-
ing in order to prevent non-uniform pitch.
• When performing an auto cut operation after not using the product for some time, feed at least
40 mm of paper. This prevents paper jams inside the auto cutter.
Appendix A Product Specifications
Approx. 27 mm
Approx.
10 mm
Paper feed direction
109
Advertisement
Table of Contents
