Installation - Epson EPL-N4000 Service Manual

EPSON EPL-N4000/EPL-N4000+ Optional Finisher Stapler
Belt Clamp
Rear Belt
Limit
Actuator
Pulley
Tension Spring
Belt
Drive Gear
Figure 3-50. Rear Drive Belt

3.4.42.2 Installation

1. Install the Rear Drive Belt as shown in the Figure 3-50.
2. Install the Drive Gear to the shaft and secure it with E ring.
3. Slide the Rear Belt around the Clamp.
4. Secure the Clamp to the Tray frame with two screws.
5. Install the Tension Plate to the frame and secure it with two screws.
6. Install the Limit Actuator to the frame and secure it with two screws.
7. Hang the Tension Spring on the Tension Plate.
8. Install the Sensor Bracket to the Tray frame and secure it with a screw.
Disassembly and Assembly
9. Install the Top Tray Motor. (Refer to "Top Tray Motor" on page 83)
10. Install the Front Drive Belt as shown in the Figure 3-49.
11. Install the Rear Belt to the Clamp by sliding.
12. Secure the Clamp to the Tray frame with two screws.
13. Install the Tension Plate to the frame and secure it with two screws.
14. Hang the Tension Spring to the Tension Plate.
15. Install the Top Tray Front Cover. (Refer to "Top Tray Front Cover" on
page 78)
16. Install Top Tray Assembly. (Refer to "Top Tray Assembly" on page 77)
Tension Spring
Tension Plate
Disassembly and Assembly
Revision A
85