Installation - Epson EPL-N4000 Service Manual

EPSON EPL-N4000/EPL-N4000+ Optional Finisher Stapler

3.4.53.2 Installation

1. Install the Drive Belt to the Drive Pulley.
2. Slide and install the rear end of the Paddle Shaft to the rear bearing.
3. Install the Paddle Shaft Assembly.
4. Slide and install the Front Paddle Bearing to the front end of the Paddle
Shaft.
5. Secure the rear bearing to the Exit Chute with a screw.
6. Secure the front bearing to the Exit Chute with a screw.
7. Slide and install the Paddle Drive Pulley to the rear end of the Paddle
Shaft and secure it to the Shaft with E ring.
8. Slide and install the Drive Belt to the Paddle Drive Pulley.
9. Secure the front end of the Paddle Shaft to the front bearing with E ring.
10. Install the Exit Chute Assembly to the HCS frame.
11. Secure the Exit Chute Assembly to the front side of the HCS frame with
two screws.
12. Secure the Exit Chute Assembly to the rear side of the HCS frame with
two screws.
13. Slide and install the metal bearing to the rear end of the Paddle Drive
Shaft and secure it with E ring.
14. Slide and install the gear to the rear end of the Paddle Drive Shaft and
secure it with E ring.
15. Install the Exit Shaft Assembly. (Refer to "Exit Shaft Assembly" on
page 96)
Disassembly and Assembly Disassembly and Assembly
Revision A
98