Eject Chute Assembly; Removal; Installation - Epson EPL-N4000 Service Manual

EPSON EPL-N4000/EPL-N4000+ Optional Finisher Stapler

3.4.54 Eject Chute Assembly

Refer to the exploded diagram (Figure 4-37, "Offset and Eject" on page 184).

3.4.54.1 Removal

1. Remove the Eject Cover. (Refer to "Eject Cover" on page 45)
2. Remove the screw holding the Rear Pinch Roll Bearing and slide off the
bearing to the rear.
3. Remove the screw holding the Front Pinch Roll Bearing and slide off the
bearing to the front.
4. Remove the Eject Chute Assembly from the HCS frame.

3.4.54.2 Installation

1. Place the Eject Chute Assembly as shown in the Figure 3-63, "Eject Chute
Assembly" on page 99.
2. Install the Eject Chute Assembly.
3. Hang the two arms of the Eject Chute Assembly to the Pinch Roll Shaft.
4. Slide the front Pinch Roll Bearing to the rear as two arms of the Eject
Chute Assembly comes on the Bearing.
5. Secure the Bearing to the HCS frame with a screw.
6. Slide the rear Pinch Roll Bearing to the front as two arms of the Eject
Chute Assembly comes on the Bearing.
7. Secure the Bearing to the HCS frame with a screw.
8. Install the Eject Cover. (Refer to "Eject Cover" on page 45)
Disassembly and Assembly Disassembly and Assembly
Figure 3-63. Eject Chute Assembly
Revision A
99