Middle Tray Assembly; Removal; Installation - Epson EPL-N4000 Service Manual

EPSON EPL-N4000/EPL-N4000+ Optional Finisher Stapler

3.4.26 Middle Tray Assembly

Refer to the exploded diagram (Figure 4-31, "Middle Tray" on page 175).

3.4.26.1 Removal

1. Remove the HCS from the printer. (Refer to "Finisher Stapler" on
page 35)
2. Remove the Harness Cover. (Refer to "Harness Cover" on page 46)
3. Remove the bottom Harness Guide Cover.
4. Release wires under the Harness Guide from the clip.
5. Pull out J887A, J870, J872A, and J873A.
6. Remove the screw securing bottom Harness Guide and remove the
Bottom Harness Guide.
7. Remove the top Harness Guide Cover.
8. Remove the screw holing top Harness Guide and remove the top Harness
Guide.
9. Remove two screws on the bottom of the Middle Tray Assembly securing
the Assembly to the HCS frame.
10. Loosen two screws on the top of the Middle Tray Assembly securing the
Assembly to the HCS frame.
11. Lift the Middle Tray Assembly out of two screw holes and remove the
Assembly from the HCS frame.

3.4.26.2 Installation

1. Hang the Middle Tray Assembly on two screws on the top of HCS frame.
2. Fasten the screws.
3. Secure the bottom of the Assembly to the HCS frame with two screws.
4. Let the Middle Tray Assembly wire harness through the slot on the
bottom of the Harness Guide.
5. Install the Top Harness Guide and secure it to the HCS frame with a
screw.
Disassembly and Assembly
6. Install the top Harness Guide Cove.
7. Install the bottom Harness Guide and secure it to the HCS frame with a
screw.
8. Connect J877A, J870, J872A, and J873A.
9. Secure wires under the clip.
10. Install the bottom Harness Guide Cover.
11. Install the Harness Cover. (Refer to "Harness Cover" on page 46)
12. Install Bottom Tray Assembly. (Refer to "Bottom (Lower) Tray Assembly"
on page 57)
Middle Tray
Assembly
J871
Top Harness Guide
Bottom Harness Guide
Disassembly and Assembly
J874A
J875A
J830A
Figure 3-32. Middle Tray Assembly
Revision A
Loosen Only
Harness Guide
Cover
Harness Guide
Cover
67