Transport Assembly; Removal; Installation - Epson EPL-N4000 Service Manual

EPSON EPL-N4000/EPL-N4000+ Optional Finisher Stapler

3.4.84 Transport Assembly

Refer to the exploded diagram (Figure 4-24, "HCS Transport" on page 165).

3.4.84.1 Removal

1. Remove the HCS from the printer. (Refer to "Finisher Stapler" on
page 35)
2. Remove two screws securing the Transport Rear Cover to the Transport
Assembly and remove the Cover.
3. Pull out J256, J262A, J263A, and J268A.
4. Lock two Support Arms under the Transport Assembly and lower the
Assembly.
5. Pull out two K Clips from the Pivot Shafts at the front and the rear of the
Transport Assembly.
6. Shift the Transport Assembly to the left and remove the front Pivot Shaft
and remove the front side of the Assembly from the HCS frame.
7. Shift the Transport Assembly to the right and remove the rear Pivot Shaft
and remove the Assembly.

3.4.84.2 Installation

1. Lock two Support Arms under the Transport Assembly.
2. Place the Transport Assembly vertically as shown in the Figure 3-93.
3. Insert the rear Pivot Shaft of the Transport Assembly to the rear hole of
the Transport Bracket.
4. Insert the front Pivot Shaft of the Transport Assembly to the front hole of
the Transport Bracket.
5. Set two K Clips in and secure the front and rear Pivot Shaft.
6. Lift the Transport Assembly and place it horizontally. Lower two Support
Arms under the Assembly and lock them.
7. Connect J256M, J262A, J263A, and J268A.
8. Place the Transport Rear Cover against the Transport Assembly as shown
in the Figure 3-93 and secure it with two screws.
Disassembly and Assembly
9. Install the HCS to the printer. (Refer to "Finisher Stapler" on page 35)
Disassembly and Assembly
Figure 3-93. Transport Assembly
Revision A
130