Installation - Epson EPL-N4000 Service Manual

EPSON EPL-N4000/EPL-N4000+ Optional Finisher Stapler

3.4.15.2 Installation

1. Place the R/H Rack Cover close to the HCS frame.
2. Connect J274 to the Lower Limit Switch.
3. Connect J273 to the Upper Limit Switch.
4. Install R/H Rack Cover to the HCS frame and secure it with seven screws.
5. Place the Rail as shown in the Figure 3-20 and slide the two Runners to
the grooves on the HCS frame.
6. Secure the Rails to the grooves with six screws.
7. Install the Elevator Hinge Bracket to the R/H Rack Cover and secure it with
four screws.
8. Install Elevator Drive Bracket to the Hinge Bracket and secure it with four
screws.
9. Install L/H Cover Low. (Refer to "L/H Cover Low" on page 44)
10. Install Top Tray Assembly. (Refer to "Top Tray Assembly" on page 77)
11. Install Middle Tray Assembly. (Refer to "Middle Tray Assembly" on
page 67)
12. Install Bottom Tray Assembly. (Refer to "Bottom (Lower) Tray Assembly"
on page 57)
Disassembly and Assembly Disassembly and Assembly
Revision A
55