Installation - Epson EPL-N4000 Service Manual

EPSON EPL-N4000/EPL-N4000+ Optional Finisher Stapler

3.4.64.2 Installation

1. Place two Compiler Cover Interlock Switches as shown in the Figure 3-73.
2. Ensure the Switch Actuator is under the Interlock Actuator and install two
Compiler Cover Interlock Switches to the HCS frame.
3. Connect J272A to the Compiler Cover Interlock Switch next to the frame.
4. Connect J272B to the other Compiler Cover Interlock Switch.
5. Ensure the Switch Actuator is under the Eject Chute Assembly and install
two Compiler Cover Interlock Switches to the HCS frame.
6. Secure the Safety Switch to the HCS frame with two screws.
7. Connect J855B to the Safety Switch.
8. If the Harness Holder is removed, install it and secure it to the HCS frame
with two screws.
9. Install the Unload While Run Switch. (Refer to "Unload While Run
Switch" on page 111)
10. Install the Front Cover Inner Assembly. (Refer to "Front Cover Inner
Assembly" on page 41)
Disassembly and Assembly Disassembly and Assembly
Revision A
110