Middle Tray; Removal; Installation - Epson EPL-N4000 Service Manual

EPSON EPL-N4000/EPL-N4000+ Optional Finisher Stapler

3.4.30 Middle Tray

Refer to the exploded diagram (Figure 4-31, "Middle Tray" on page 175).

3.4.30.1 Removal

1. Remove Middle Tray Assembly. (Refer to "Middle Tray Assembly" on
page 67)
2. Remove Middle Tray Drive Belts. (Refer to "Middle Tray Drive Belts" on
page 74)
3. Remove Middle Tray Paper Sensor. (Refer to "Middle Tray Paper Sensor"
on page 72)
4. Remove screw securing Sensor wire harness to the bottom of the Tray
and remove the harness.
5. Remove the Tray by sliding it off from the grooves of the Front Tray frame
and the Rear Tray frame. (Figure 1)
6. Remove four screws securing the Carriage to the Tray and remove the
Tray. (Figure 2)

3.4.30.2 Installation

1. Install the Carriage to the Tray and secure it with four screws.
2. Install the Tray into the grooves of Front Tray Frame and Rear Tray
Frame.
3. Install Sensor wire harness to the bottom of the Tray and secure it with
screw.
4. Install Middle Tray Paper Sensor. (Refer to "Middle Tray Paper Sensor"
on page 72)
5. Install Middle Tray Drive Belts. (Refer to "Middle Tray Drive Belts" on
page 74) to the both sides of the frame.
6. Install Middle Tray Assembly. (Refer to "Middle Tray Assembly" on
page 67)
Disassembly and Assembly
Frame
Disassembly and Assembly
Carriage
Figure 3-36. Middle Tray
Revision A
Frame
Tray
71