EPSON EPL-N4000/EPL-N4000+ Optional Finisher Stapler
3.4.69 Set Clamp Motor Drive Belt
Refer to the exploded diagram (Figure 4-41, "Rear Frame 1" on page 188).
3.4.69.1 Removal
1. Remove the Set Clamp Motor. (Refer to "Set Clamp Motor" on page 115)
2. Remove the Set Clamp Motor Drive Belt from the Eject Pulley.
3.4.69.2 Installation
1. Hang the Motor Drive Belt on the Eject Pulley.
2. Install the Set Clamp Motor. (Refer to "Set Clamp Motor" on page 115)
Figure 3-78. Set Clamp Motor Drive Belt
Disassembly and Assembly
3.4.70 Set Clamp Home Sensor
Refer to the exploded diagram (Figure 4-41, "Rear Frame 1" on page 188).
3.4.70.1 Removal
1. Remove the Set Clamp Motor. (Refer to "Set Clamp Motor" on page 115)
NOTE: For the removal of the Set Clamp Home Sensor, there is no need
for the Motor to be removed from the Bracket.
2. Release the latches, which secures the Sensor to the Bracket, and remove
the Sensor.
3.4.70.2 Installation
1. Insert the Set Clamp Home Sensor to the Bracket as shown in the Figure
3-79.
2. Insert the hook into the hole of the Motor Bracket and push the latches in.
3. Install the Set Clamp Motor. (Refer to "Set Clamp Motor" on page 115)
Disassembly and Assembly
Figure 3-79. Set Clamp Home Sensor
Revision A
116