Eject Shaft Assemblies; Removal; Installation - Epson EPL-N4000 Service Manual

Optional finisher stapler
Hide thumbs Also See for EPL-N4000:
Table of Contents

Advertisement

EPSON EPL-N4000/EPL-N4000+ Optional Finisher Stapler

3.4.50 Eject Shaft Assemblies

Refer to the exploded diagram (Figure 4-35, "Tray Eject" on page 182).

3.4.50.1 Removal

1. Remove the Eject Cover. (Refer to "Eject Cover" on page 45)
2. Remove the Top Tray Assembly. (Refer to "Top Tray Assembly" on
page 77)
3. Remove four screws securing the Ejector Roll Chute to the HCS frame and
remove the Chute.
4. Remove the Set Clamp Motor. (Refer to "Set Clamp Motor" on page 115)
5. Remove E ring binding the Set Clamp Actuator to the Shaft 1 and remove
the Actuator and Pulley and metal bearing.
6. Remove E ring binding front metal bearing to the Shaft 1 and remove the
front bearing.
7. Remove E ring binding Offset Lever to the Shaft 2 and remove the Offset
Lever.
8. Remove E ring binding the Eject Gear to the Shaft 2 and remove the Eject
Gear.
9. Remove the screw securing the rear plastic bearing to the Shaft 2 and
remove the rear bearing from the Shaft.
10. Remove two screws securing the front plastic bearing to the Shaft 2 and
remove the front bearing from the shaft.
11. Remove the Shaft 1 and the Shaft 2 (the Eject Shaft Assemblies) as one
unit.
Disassembly and Assembly

3.4.50.2 Installation

1. Place the Eject Shaft Assemblies as shown in the Figure 3-58 and install
them to the HCS frame.
2. Install the front metal bearing and rear metal bearing by sliding them
from the both ends of the Shaft 1.
3. Place the Tray as the front and rear arms of the Compiler Tray parallels
with the Shaft 1.
4. Slide the front metal bearing and the rear metal bearing into the cutouts
of the HCS frame and slide them on the arms of Compiler Tray.
Disassembly and Assembly
Figure 3-58. Eject Shaft Assemblies
Revision A
93

Advertisement

Table of Contents
loading

This manual is also suitable for:

Epl-n4000+

Table of Contents