EPSON EPL-N4000/EPL-N4000+ Optional Finisher Stapler
3.4.83 IN Gate Support Actuator
Refer to the exploded diagram (Figure 4-46, "HCS DOC" on page 193).
3.4.83.1 Removal
1. Remove the IN Gate Support Assembly. (Refer to "IN Gate Support
Assembly" on page 128)
2. Open the latches of the Actuator and pull out the Actuator from the Shaft.
3.4.83.2 Installation
1. Place the IN Gate Actuator as shown in the Figure 3-92.
2. Push in the IN Gate Actuator to the Shaft until the latches snaps.
3. Install the IN Gate Support Assembly. (Refer to "IN Gate Support
Assembly" on page 128)
Figure 3-92. IN Gate Support Assembly
Disassembly and Assembly
Disassembly and Assembly
Revision A
129