Stacker Elevator Motor; Removal; Installation - Epson EPL-N4000 Service Manual

EPSON EPL-N4000/EPL-N4000+ Optional Finisher Stapler

3.4.16 Stacker Elevator Motor

Refer to the exploded diagram (Figure 4-28, "Rail and Trays" on page 170).

3.4.16.1 Removal

1. Remove L/H Cover Low. (Refer to "L/H Cover Low" on page 44)
2. Remove two screws securing Motor Plate to the Motor Bracket.
3. Slide the Motor Plate to enable Motor Pulley to move freely from the
Drive Belt, and remove Motor Plate with Elevator Motor from the Bracket.
4. Pull out J865.
5. Remove the E ring connecting the Motor Pulley to the Motor Shaft and
remove the pulley.
6. Remove two screws securing Elevator Motor to the Motor Plate and
remove the motor.

3.4.16.2 Installation

1. Place the Elevator Motor against Motor Plate as shown in the Figure 3-21.
2. Secure the Motor to the Plate with two screws.
3. Insert the Motor Pulley into the Motor shaft.
4. Install Pulley to the Motor shaft with E ring.
5. Install Elevator Motor with Motor Plate to the hole of Motor Bracket and
hang the Drive Belt around the Motor Pulley.
6. Secure the Motor Plate to the Motor Bracket with two screws.
7. Connect J865.
8. Install L/H Cover Low. (Refer to "L/H Cover Low" on page 44)
Disassembly and Assembly
Drive Belt
Disassembly and Assembly
J865
Motor Pulley
Figure 3-21. Stacker Elevator Motor
Revision A
Elevator Motor
Motor Plate
Motor Pulley
Motor Bracket
56