EPSON EPL-N4000/EPL-N4000+ Optional Finisher Stapler
3.3.2 Removal
1. Disconnect the HCS interface cable from the printer.
2. Remove a screw from the edge of the Docking Rail.
3. Slide the Finisher Stapler away from the printer.
4. Disconnect HCS AC power cable from the printer.
5. Put the Shaft-Transport back and face down the Transport Assembly.
6. Remove Bracket Assembly EMI.
7. Remove the Docking Rail from the right side of the printer's bottom.
8. Remove the Docking Rail from the left side of the printer's bottom.
9. Remove DOC HCS.
Disassembly and Assembly
Installation and Removal of Finisher Stapler and Stapler Cartridge
Figure 3-2. Removing the Finisher Stapler
Revision A
37