Top Tray Assembly; Removal; Installation - Epson EPL-N4000 Service Manual

EPSON EPL-N4000/EPL-N4000+ Optional Finisher Stapler

3.4.35 Top Tray Assembly

Refer to the exploded diagram (Figure 4-33, "Top Tray" on page 179).

3.4.35.1 Removal

1. Remove the HCS from the printer. (Refer to "Finisher Stapler" on
page 35)
2. Remove the Harness Cover. (Refer to "Harness Cover" on page 46)
3. Remove the Harness Guide Cover.
4. Release wires under the Harness Guide from the clip.
5. Pull out J255, J292, J294A, J295A and J296A.
6. Remove the screw securing top Harness Guide and remove the Harness
Guide.
7. Remove two screws on the bottom of the Top Tray Assembly securing
the Assembly to the HCS frame.
8. Loosen two screws on the top of the Top Tray Assembly securing the
Assembly to the HCS frame.
9. Lift the Top Tray Assembly out of two screw holes and remove the
Assembly from the HCS frame.

3.4.35.2 Installation

1. Hang the Top Tray Assembly on the HCS frame as the two screws on the
top of the HCS frame go under the screw holes of the Top Tray Assembly.
2. Fasten two screws.
3. Secure the bottom of the Assembly to the HCS frame with two screws.
4. Let the Top Tray Assembly wire harness through the slot at the bottom of
the Harness Guide.
5. Install the top Harness Guide and secure it to the HCS frame with a screw.
6. Connect J255, J292A, J294A, J295A and J296A.
7. Install top Harness Cover. (Refer to "Harness Cover" on page 46)
8. Connect HCS to the printer. (Refer to "Finisher Stapler" on page 35)
Disassembly and Assembly
Top Tray
Assembly
J255
Top Harness Guide
Disassembly and Assembly
J292A
J296A
Harness Guide Cover
Figure 3-42. Top Tray Assembly
Revision A
Loosen Only
J295A
J294A
77