Offset Home Sensor; Removal; Installation - Epson EPL-N4000 Service Manual

EPSON EPL-N4000/EPL-N4000+ Optional Finisher Stapler

3.4.78 Offset Home Sensor

Refer to the exploded diagram (Figure 4-43, "Rear Frame 3" on page 190).

3.4.78.1 Removal

1. Remove the Rear Cover. (Refer to "Rear Cover" on page 46)
2. Remove two screws securing the Offset Home Sensor Bracket to the HCS
frame and remove the Bracket.
3. Remove the wire harness from the Wire Clamp on the Eject Bracket.
4. Pull out J844 from the Offset Home Sensor.
5. Release the latches, which secures the Sensor to the Bracket, and remove
the Sensor from the Bracket.

3.4.78.2 Installation

1. Place the Offset Home Sensor against the Eject Clamp Sensor Bracket as
shown in the Figure 3-87 and push the latches into the bracket.
2. Connect J844 to the Sensor.
3. Install the wire harness to the Wire Clamp on the Eject Bracket.
4. Install the Offset Home Sensor Bracket to the HCS frame.
5. Secure the Bracket to the Frame with two screws.
6. Install the Rear Cover. (Refer to "Rear Cover" on page 46)
Disassembly and Assembly Disassembly and Assembly
Figure 3-87. Offset Home Sensor
Revision A
124