Table of Contents
Advertisement
Installation and Operation
After you have set up your printer and loaded the paper (following
the directions in the LX-90 User's Manual), you are ready to plug in
your Printer Interface Cartridge (PIP™) and begin printing.
Inserting the Printer Interface Cartridge
Inserting the PIC is easy. The cartridge slides into the rectangular
opening, as shown in the LX-90 manual. Be sure the printer is OFF
when you insert the PIC. Once the PIC is installed, you are ready to
test your printer.
Printing the Test Patterns
It's time to see the LX-90 in action. You'll start with a test pattern.
Don't connect the printer to your computer yet-just follow these
steps:
1. Make sure that your printer has paper in it and that the power
switch (on the right side of the printer) is off.
2. Press the
LF
turn the printer on with the power switch.
The LX-90 begins printing letters, numbers, and symbols in the
draft mode. It won't stop until you turn it off or until it gets near the
end of the paper.
To see the same test in the NLQ (Near Letter Quality) mode, turn
the printer on while pressing the FF button. Figure l-1 shows what
both test patterns look like.
Chapter
button on the control panel, and at the same time,
1
Advertisement
Table of Contents
