Eject Clamp Sensor; Removal; Installation - Epson EPL-N4000 Service Manual

EPSON EPL-N4000/EPL-N4000+ Optional Finisher Stapler

3.4.77 Eject Clamp Sensor

Refer to the exploded diagram (Figure 4-43, "Rear Frame 3" on page 190).

3.4.77.1 Removal

1. Remove the Rear Cover. (Refer to "Rear Cover" on page 46)
2. Remove the wire harness from the Wire Clamp on the Eject Bracket.
3. Remove one screw securing the Eject Clamp Sensor Bracket to the Eject
Bracket and remove the Sensor Bracket along with the Sensor.
4. Pull out J841 from the Sensor.
5. Release the latches, which secures the Sensor to the Bracket, and remove
the Sensor from the Bracket.

3.4.77.2 Installation

1. Place the Eject Clamp Sensor against the Eject Clamp Sensor Bracket as
shown in the Figure 3-86 and push the latches into the bracket.
2. Connect J841 to the Sensor.
3. Install the Eject Clamp Sensor to the Eject Bracket.
4. Secure the Sensor Bracket to the Eject Bracket with one screw.
5. Install the wire harness to the Wire Clamp on the Eject Bracket.
6. Install the Rear Cover. (Refer to "Rear Cover" on page 46)
Disassembly and Assembly Disassembly and Assembly
Figure 3-86. Eject Clamp Sensor
Revision A
123