In Gate Solenoid Assembly; Removal; Installation - Epson EPL-N4000 Service Manual

EPSON EPL-N4000/EPL-N4000+ Optional Finisher Stapler

3.4.87 IN Gate Solenoid Assembly

Refer to the exploded diagram (Figure 4-47, "Frame Transport, Rear" on page
194).

3.4.87.1 Removal

1. Remove the Transport Assembly. (Refer to "Transport Assembly" on
page 130)
2. Remove the wire harness (P256M) of the Solenoid from the wire clip.
3. Remove one screw securing the Ground Wire to the Solenoid Assembly.
4. Remove two screws securing the Solenoid Assembly to the Bracket and
remove the Solenoid Assembly.
5. Pull out the Damper Bracket from the Solenoid Assembly.
6. Remove two screws securing the Solenoid Cover to the Solenoid.
Solenoid Plunger is pushed by the Spring. When the Solenoid
is removed from the Solenoid Cover, the Plunger will jump
out.

3.4.87.2 Installation

1. Ensure the Solenoid Spring and Link Assembly is installed to the
Solenoid Plunger correctly.
2. Insert the IN Gate Solenoid to the Solenoid Cover and hang the hole of
the Link Assembly to the projection of the Cover.
3. Secure the Solenoid Cover to the Solenoid with two screws.
4. Insert the Damper Bracket to the Solenoid Cover with the form rubber
toward the Solenoid coil.
5. Hang the projection on the Cover to the hole of the Bracket and push in
the Solenoid Assembly and match two screw threaded holes.
6. Secure the Solenoid Assembly to the Bracket with two screws.
Disassembly and Assembly
7. Install the Ground Wire to the Solenoid Assembly and secure the wire
one screw.
8. Reinstall the Ground Wire to the Solenoid Assembly and use one screw to
secure the wire.
9. Place the wire according to the distribution board and put the wire under
the harness clip on the Bracket.
10. Install the Transport Assembly. (Refer to "Transport Assembly" on
page 130)
Disassembly and Assembly
Figure 3-96. IN Gate Solenoid Assembly
Revision A
134