Stapler Assembly; Removal; Installation - Epson EPL-N4000 Service Manual

EPSON EPL-N4000/EPL-N4000+ Optional Finisher Stapler

3.4.58 Stapler Assembly

Refer to the exploded diagram (Figure 4-38, "Stapler" on page 185).

3.4.58.1 Removal

1. Remove the L/H Cover. (Refer to "L/H Cover" on page 43)
2. Remove the Front Cover Inner Assembly. (Refer to "Front Cover Inner
Assembly" on page 41)
3. Push the Stapler Assembly to the front of the HCS.
4. Pull out J862 from the Stapler Assembly.
5. Set the wire harness clip off from the side of the Stapler Assembly.
6. Secure two screws holding the Stapler Assembly to the Slider Bracket
and remove the Stapler Assembly.
7. Release the wire harness from the wire harness clip at the back of the
Stapler Assembly.

3.4.58.2 Installation

1. Place the Stapler Assembly close to the Slider Bracket.
2. Let the wire harness through the wire clip close the Stapler Assembly.
3. Ensure the tab on the back of the Stapler comes through the cutout of the
Slider Bracket and install the Stapler Assembly to the Bracket.
4. Secure the Assembly to the Rail with two screws.
5. Install the Wire Harness Clip to the side of the Stapler Assembly.
6. Connect J862 to the Stapler Assembly.
7. Install the Front Cover Inner Assembly. (Refer to "Front Cover Inner
Assembly" on page 41)
8. Install the L/H Cover. (Refer to "L/H Cover" on page 43)
Disassembly and Assembly Disassembly and Assembly
Figure 3-67. Stapler Assembly
Revision A
103