Middle Tray Drive Belts; Removal - Epson EPL-N4000 Service Manual

EPSON EPL-N4000/EPL-N4000+ Optional Finisher Stapler

3.4.33 Middle Tray Drive Belts

Refer to the exploded diagram (Figure 4-31, "Middle Tray" on page 175).

3.4.33.1 Removal

1. Remove the Middle Tray Assembly. (Refer to "Middle Tray Assembly" on
page 67)
2. Remove the Middle Tray Front Cover. (Refer to "Middle Tray Front Cover"
on page 68)
3. Remove the Tension Spring from the Tension Plate. (Figure 3-30)
4. Remove two screws securing Tension Plate to the Tray frame and remove
the Plate.
5. Remove two screws securing Belt Clamp to the Tray and remove the
Clamp.
6. Remove the Belt from the Clamp by sliding.
7. Remove the E ring binding the Drive Gear to the Shaft and remove the
Gear.
8. Remove the Front Drive Gear.
Disassembly and Assembly
Front Belt
Pulley
Belt
9. Remove the Middle Tray Motor. (Refer to "Middle Tray Motor" on
page 73)
10. Remove the screw securing the Sensor Bracket to the Tray frame and
remove the Bracket.
11. Remove the Tension Spring from the Tension Plate. (Figure 3-31)
12. Remove two screws securing the Limit Actuator to the Tray frame and
remove the Actuator.
13. Remove two screws securing the Tension Plate to the Tray frame and
remove the Tension Plate.
14. Remove two screws securing the Belt Clamp to the Tray frame and
remove the Belt Clamp.
15. Remove the Belt from the Clamp by sliding.
16. Remove the E ring binding the Drive Gear to the shaft and remove the
Drive Gear.
17. Remove the Rear Drive Belt.
Disassembly and Assembly
Tension Spring
Tension Plate
Belt Clamp
Tension Spring
Figure 3-39. Front Drive Belt
Revision A
74