Eject Bracket Assembly; Removal; Installation - Epson EPL-N4000 Service Manual

EPSON EPL-N4000/EPL-N4000+ Optional Finisher Stapler

3.4.75 Eject Bracket Assembly

Refer to the exploded diagram (Figure 4-43, "Rear Frame 3" on page 190).

3.4.75.1 Removal

1. Remove the HCS from the printer. (Refer to "Finisher Stapler" on
page 35)
2. Remove the Rear Cover. (Refer to "Rear Cover" on page 46)
3. Release the wire harness from the Harness Bracket Assembly.
4. Remove three screws securing the Harness Bracket Assembly to the HCS
frame and remove the Harness Bracket Assembly.
5. Remove the Offset Home Sensor. (Refer to "Offset Home Sensor" on
page 124)
6. Remove the Eject Clamp Sensor. (Refer to "Eject Clamp Sensor" on
page 123)
7. Remove Tension Spring from the Eject Bracket Assembly.
8. Remove four screws securing the Eject Bracket Assembly to the HCS
frame and remove the Eject Bracket Assembly.

3.4.75.2 Installation

1. Place the Eject Clamp Actuator as the Cam Clamp Spring touches the
actuator as shown in the Figure 3-84.
2. Install the Eject Bracket Assembly to the HCS frame as the tab of the HCS
frame goes in the long slot of the Eject Bracket Assembly.
3. Install the Lever as the Lever touches the Clamp Up Lever as shown in the
Figure 3-84.
4. Put the protrusion of the Offset Lever on the groove of the Offset Cam.
5. Secure the Eject Bracket Assembly to the HCS frame with four screws.
6. Hang the Tension Spring on the Eject Bracket Assembly.
7. Install the Eject Clamp Sensor.(Refer to "Eject Clamp Sensor" on
page 123)
Disassembly and Assembly
8. Install the Offset Home Sensor. (Refer to "Offset Home Sensor" on
page 124)
9. Install the Harness Bracket Assembly to the HCS frame with three screws.
10. Insert the wire harness under the Clip on the Harness Bracket.
11. Install the Rear Cover. (Refer to "Rear Cover" on page 46)
12. Install the HCS to the printer. (Refer to "Finisher Stapler" on page 35)
Disassembly and Assembly
Figure 3-84. Eject Bracket Assembly
Revision A
121