Set Clamp Motor; Removal; Installation - Epson EPL-N4000 Service Manual

EPSON EPL-N4000/EPL-N4000+ Optional Finisher Stapler

3.4.68 Set Clamp Motor

Refer to the exploded diagram (Figure 4-41, "Rear Frame 1" on page 188).

3.4.68.1 Removal

1. Remove the Eject Bracket Assembly. (Refer to "Eject Bracket Assembly"
on page 121)
2. Remove the Finisher Stapler PWB Cover. (Refer to "Finisher Stapler PWB
Cover and Connector Cover" on page 48)
3. Pull out J864 and J842.
4. Remove two screws securing the Motor Bracket to the HCS frame and
remove the Bracket.
5. Remove the Set Clamp Drive Belt from the Motor Pulley and remove the
Motor Bracket.
6. Remove E ring binding Shaft Pulley to the Motor and remove the Shaft
Pulley.
7. Remove two screws securing the Set Clamp Motor to the Motor Bracket
and remove the Motor.

3.4.68.2 Installation

1. Install the Set Clamp Motor to the Motor Bracket with two screws.
2. Install the Shaft Pulley to the Motor Shaft as shown in the Figure 3-77.
3. Secure the Pulley to the Shaft with E ring.
4. Hang the Set Clamp Drive Belt to the Shaft Pulley and install the Motor
Bracket to the HCS frame.
5. Secure the Motor Bracket to the HCS frame with two screws.
6. Connect J864 and J842.
7. Install the Finisher Stapler PWB Cover. (Refer to "Finisher Stapler PWB
Cover and Connector Cover" on page 48)
8. Install the Eject Bracket Assembly. (Refer to "Eject Bracket Assembly" on
page 121)
Disassembly and Assembly Disassembly and Assembly
Figure 3-77. Set Clamp Motor
Revision A
115