Transport Exit Sensor; Removal; Installation - Epson EPL-N4000 Service Manual

EPSON EPL-N4000/EPL-N4000+ Optional Finisher Stapler

3.4.94 Transport Exit Sensor

Refer to the exploded diagram (Figure 4-48, "Frame Transport, Open" on page
195).

3.4.94.1 Removal

1. Remove the HCS from the printer. (Refer to "Finisher Stapler" on
page 35)
2. Open the Transport Cover.
3. Release two latcheses, which secure the Transport Exit Sensor Cover to
the Transport and remove the Cover carefully with force.
4. Pull out J263 from the Transport Exit Sensor.
5. Release the latches, which secures the Transport Exit Sensor to the
Transport and remove the Sensor from the Transport.

3.4.94.2 Installation

1. Install the Transport Exit Sensor to the bottom of the Transport Assembly
toward the direction shown in the Figure 3-101.
2. Connect J26359 to the Transport Exit Sensor.
3. Install the Transport Exit Sensor Cover to the Transport. First, insert two
latcheses to the latch hole of the Transport and then push the Cover
down.
4. Close the Transport Cover.
5. Install the HCS to the printer. (Refer to "Finisher Stapler" on page 35)
Disassembly and Assembly Disassembly and Assembly
Figure 3-103. Transport Exit Sensor
Revision A
142