Epson EPL-N4000 Service Manual page 153

EPSON EPL-N4000/EPL-N4000+ Optional Finisher Stapler
VARIOUS MOTORS FINISHER PWB
The following tables show the signal names in the wiring diagram below.
Signal
STACKER MID DOWN CCW Control signal to shift down the Stacker Mid.
STACKER MID UP CW Control signal to shift up the Stacker Mid.
STACKER LOW DOWN CCW Control signal to shift down the Stacker Low.
STACKER LOW UP CW Control signal to shift up the Stacker Low.
EJECT CLAMP & OFFSET Control signal to shift down the Eject Clamp
MOT CW Offset.
EJECT CLAMP & OFFSET
Control signal to shift up the Eject Clamp Offset.
MOT CCW
SET CLAMP MOT- Control signal to shift the Set Clamp Offset Motor.
SET CLAMP MOT+ Control signal to shift the Set Clamp Offset Motor.
Supervisory signal for the obstruction at the
STACKER TOP SAFETY IN
lower side of the Top Tray and Middle Tray.
STACKER TOP SAFETY Supervisory signal for the obstruction at the
OUT lower side of the Top Tray and Middle Tray.
STACKER TOP UP CW Control signal to shift up the Stacker Top.
STACKER TOP DOWN CCW Control signal to shift sown the Stacker Top.
Supervisory signal for Stacker abnormal rise.
High=Stacker has reached the upper limit
STACKER UPPER LIMIT SW
position.
Low=Stacker is under the upper limit position.
Supervisory signal for Stacker abnormal fall.
High=Stacker has reached the lower limit
STACKER LOWER LIMIT SW
position.
Low=Stacker is above the lower limit position.
STACKER UNIT UP CCW Control signal to shift up the Stacker Tray Unit.
STACKER UNIT DOWN CW Control signal to shift down the Stacker Tray Unit.
Appendix
Explanation
Wiring Diagram and Signal Data
Figure 4-10. Wiring Diagram 9
Revision A
153