End Wall Motor; Removal - Epson EPL-N4000 Service Manual

EPSON EPL-N4000/EPL-N4000+ Optional Finisher Stapler

3.4.66 End Wall Motor

Refer to the exploded diagram (Figure 4-40, "Front Frame" on page 187).

3.4.66.1 Removal

1. Remove the Front Cover Inner Assembly. (Refer to "Front Cover Inner
Assembly" on page 41)
2. Remove the Unload While Run Switch. (Refer to "Unload While Run
Switch" on page 111)
3. Remove two screws securing the Harness Holder and remove the Holder.
4. Remove the screw securing the Harness Clip to the End Wall Solenoid.
5. Remove the End Wall Spring.
6. Remove two screws securing the End Wall Motor Bracket to the HCS
frame and remove the Bracket along with the End Wall Motor.
7. Release the End Wall Motor wire harness from the harness clip.
8. Pull out J868.
9. Remove two screws securing the End Wall Motor to the Bracket and
remove the Motor.
Disassembly and Assembly Disassembly and Assembly
Figure 3-75. End Wall Motor
Revision A
112