Tamper Motor Drive Belt; Removal; Installation - Epson EPL-N4000 Service Manual

EPSON EPL-N4000/EPL-N4000+ Optional Finisher Stapler

3.4.48 Tamper Motor Drive Belt

Refer to the exploded diagram (Figure 4-35, "Tray Eject" on page 182).

3.4.48.1 Removal

1. Remove the Tamper Motor. (Refer to "Tamper Motor" on page 87)
2. Loosen the screw for the Belt Holder and remove the Belt from the Holder
by sliding it off.
3. Remove the Belt from the Tension Pulley by sliding it off.

3.4.48.2 Installation

1. Place the Tamper Motor Drive Belt as the ribs come inside the Belt loop.
2. Install the Belt to the Tension Pulley by sliding it.
3. Insert the Belt between the top and bottom of the Belt Holder and fasten
the screw for the Belt Holder.
4. Install the Tamper Motor. (Follow the installing process of the Tamper
Motor to step 6.)
5. Fasten the Belt Tension Screw enough as the Belt does not come off
when the Tamper Motor is running.
6. Install the Tie Plate to the HCS frame and secure it with four screws.
7. Install the L/H Cover. (Refer to "L/H Cover" on page 43)
8. Connect the HCS to the printer. (Refer to "Finisher Stapler" on page 35)
Disassembly and Assembly Disassembly and Assembly
Figure 3-56. Tamper Motor Drive Belt
Revision A
91