Key Features - Cisco ONS 15454 DWDM Reference Manual

8.4.1 Key Features

You can install TXP_MR_10E cards in Slots 1 to 6 and 12 to 17 and provision the cards in a linear
configuration, BLSR/MS-SPRing, path protection/SNCP, or a regenerator. The card can be used in the
middle of BLSR/MS-SPRing or 1+1 spans when the card is configured for transparent termination mode.
The TXP_MR_10E card features a 1550-nm tunable laser (C band) or a 1580-nm tunable laser (L band)
for the trunk port and a separately orderable ONS-XC-10G-S1 1310-nm or ONS-XC-10G-L2 1550-nm
laser XFP module for the client port.
When the ONS-XC-10G-L2 XFP is installed, the TXP_MR_10E card must be installed in Slots 5, 6, 12
Note
or 13.
On its faceplate, the TXP_MR_10E card contains two transmit and receive connector pairs, one for the
trunk port and one for the client port. Each connector pair is labeled.
8.4.1 Key Features
The key features of the TXP_MR_10E card are:
•
•
•
8.4.2 Faceplate and Block Diagram
Figure 8-12
Cisco ONS 15454 DWDM Reference Manual, R8.5
8-12
A tri-rate client interface (available through the ONS-XC-10G-S1 XFP, ordered separately)
OC-192 (SR1)
–
10GE (10GBASE-LR)
–
10G-FC (1200-SM-LL-L)
–
OC-192 to ITU-T G.709 OTU2 provisionable synchronous and asynchronous mapping
The MTU setting is used to display the OverSizePkts counters on the receiving trunk and client port
interfaces. Traffic of frame sizes up to 65535 bytes pass without any packet drops, from the client
port to the trunk port and vice versa irrespective of the MTU setting.
shows the TXP_MR_10E faceplate and block diagram.
Chapter 8 Transponder and Muxponder Cards
78-18343-02