Table of Contents
Advertisement
68
C
3: G
S
HAPTER
ETTING
TARTED
3 Enter the following information (by selecting the appropriate options and
responding to the prompts that appear at the bottom of the screen) to enable IP
Ethernet connectors:
IP Address—Provided by the network administrator. This is the IP address of the
PathBuilder S600 Management CPU.
You should consult the network administrator to obtain an IP address for the
PathBuilder S600 which will allow its 10BaseT Management port to co-exist with
hosts on its local LAN.
Subnet Mask—Provided by the network administrator. The subnet mask
identifies the subnetwork containing the PathBuilder S600 SLIP management port.
4 Select [3] Previous Menu to return to the Local Host IP Configuration menu.
5 Select [3] Apply IP Configuration Changes to activate the IP address. The following
prompt appears:
This action will terminate all running TELNET/SNMP sessions.
Are you sure you want to apply IP configuration changes (Y/N)[N]?
6 Enter [Y] to apply your changes.
Configuring Trap Clients
The PathBuilder S600 can report SNMP trap alarms to a remote management
system. Trap clients are the network management stations to which you want the
PathBuilder S600 to send traps. You can specify up to four trap clients. To
configure trap clients, follow these steps:
1 From the Manage IP Network Configuration menu, select [2] Trap Client
Configuration to display the Trap Client Configuration menu, shown in Figure 39.
Figure 39 Trap Client Configuration Menu
2 Select the number corresponding to the trap client you want to configure.
Figure 40 shows the menu for configuring trap client 1.
Advertisement
Table of Contents
