Introduction
Audience Description
How to Use This Guide
A
BOUT THIS
About This Guide provides an overview of this guide, describes guide conventions,
tells you where to look for specific information and lists other publications that
may be useful.
This guide describes how to install and configure the PathBuilder S600 WAN
Access Switch (PathBuilder S600). It also provides an overview of the unit's
modules and supported applications.
This guide is intended for network administrators, system engineers, field
engineers, and other personnel responsible for installing, configuring, and
managing PathBuilder products.
If the information in the Release Notes shipped with your product differs from the
information in this guide, follow the Release Notes.
Table 1 shows where to find specific information in this guide.
Table 1 Where to Find Specific Information
If you are looking for...
Descriptions of the features and benefits of the PathBuilder S600
System specifications
Installation instructions
Information on how to get started using the PathBuilder S600
Instructions for using the PathBuilder S600 menus
Information about the specific modules and applications you can use with
the PathBuilder S600
Instructions for configuring PathBuilder S600 modules, ports, and cards
Instructions for configuring virtual interfaces
Instructions for configuring shapers
Instructions for configuring virtual circuits
Instructions for configuring bridging applications
Information about managing system alarms and lists of the alarms
supported by each of the PathBuilder S600 modules
Information about setting up loopbacks and what loopbacks specific
modules support
Information on displaying statistics and lists of the types of statistics
available for specific modules
Technical support information
G
UIDE
Turn to...
Chapter 1
Chapter 1
Chapter 2
Chapter 3
Chapter 3
Chapter 4
Chapter 5
Chapter 5
Chapter 5
Chapter 5
Chapter 5
Chapter 6
Chapter 6
Chapter 6
Appendix A
Need help?
Do you have a question about the 3C63100-AC-C - PathBuilder S600 Bridge/router and is the answer not in the manual?