Setting Application Module Status; Configuring The Shelf - 3Com 3C63100-AC-C - PathBuilder S600 Bridge/router Reference Manual

116 C 5: C P B S600 M , P , A
HAPTER ONFIGURING ATH UILDER ODULES ORTS AND PPLICATIONS
You can reset the slot to match the actual card type by entering [Y] at the
following prompt:
Do you want to configure this slot to match the actual card type (Y/N)?
Press ÔYÕ to match card type or ÔNÕ to return to previous menu.
CAUTION: Changing the card type in a slot will reset all existing configuration
data for that slot.

Setting Application Module Status

The application modules each have an administrative and an operational status (In
Service or Out of Service). You set the administrative status on the appropriate
module configuration menu. The system displays the operational status, also on
the module configuration menu.
When the administrative status is set to Out of Service, the card's configuration
menu lists the operational status as Out of Service whether or not the card is
actually operational. Once you set the administrative status to In Service, the
operational status listed will indicate the true card status (Out of Service if there is
a card failure or In Service if the card is operational).
To set up a virtual circuit, you must set the administrative status of the card and
port which will carry the circuit to In Service. For details about setting up virtual
circuits, see "Configuring Virtual Circuits" later in this chapter.
Subsequent sections tell you how to configure specific PathBuilder S600 modules.
Configuring the Shelf
From the Shelf Configuration menu, shown in Figure 81, you can get information
about the shelf and configure it by setting and unsetting the left and right power
supplies.
To display the Shelf Configuration menu:
Select [0] Shelf from the List Card menu.
Figure 81 Shelf Configuration Menu