Performing Initial Configuration; Setting Up Communication Parameters - 3Com 3C63100-AC-C - PathBuilder S600 Bridge/router Reference Manual

Performing Initial
Configuration
Setting up
Communication
Parameters
After you install the PathBuilder S600 hardware, you must complete the following
three steps in order to complete the initial configuration:
1 Set up communication parameters
2 Configure In-band Management (optional)
3 Set up passwords
4 Set the time and date
You access the menus used to perform these steps from the System
Administration menu, shown in Figure 32. To display the System Administration
menu:
From the Main menu, select [1] System Administration.
Figure 32 System Administration Menu
The following subsections provide instructions for performing the three initial
configuration steps. See Chapter 5 for instructions on configuring specific
PathBuilder S600 modules.
In order for the PathBuilder S600 to communicate to the Ethernet network, you
must set the correct communication parameters. To do this, select [3] Manage IP
Network Configuration from the System Administration menu to display the
Manage IP Network Configuration menu, shown in Figure 33.
Performing Initial Configuration 63